Adhesives for load bearing timber structures other than phenolic and aminoplastic - Test methods - Part 3: Creep deformation test at cyclic climate conditions with specimens loaded in bending shear

Comment end date 2024-07-20

Project stage codes

1. Decision on WI Proposal

2. Projektas

3. Viešoji apklausa

From 2024-05-09 till 2024-07-20

4. Closure of enquiry

5. Submission to Formal Vote

Organisation

CEN Europos standartizacijos komitetas

ICS

83.180 - Adhesives

Technical Committee

TK 70 Pulp, paper, board, adhesives

ForeignTC'S

CEN/TC 193

Number of comments

Comment start date

2024-05-09

Scope

This document specifies a method for determining the creep deformation of bonded specimens loaded in bending shear. It is applicable to adhesives used in load bearing timber structures. It is suitable for the following applications: a) for assessing the compliance of adhesives to EN 15425 and EN 16254; b) for assessing the suitability and quality of adhesives for load bearing timber structures. This test is intended primarily to obtain performance data for the classification of adhesives for load bearing timber structures according to their suitability for use in defined climatic environments. This method is not intended to provide data for structural design, and does not necessarily represent the performance of the bonded member in service.

Relations

Pakeis

prEN 15416-3