GDPR

projektai-lsd Lithuanian Standards Board
Portal for draft standards

Extended search

till

Results

Showing:
prEN 12405-2 Public enquiry
Comment end date 2026-05-07
Gas meters - Conversion devices - Part 2: Energy conversion

This European Standard specifies the requirements and tests for the construction, performance, safety and conformity of conversion devices used to determine the energy of fuel gases described in the Table 1, including those of the 1st and 2nd families according to EN 437. The energy conversion device (ECD) considered in this standard consists of an energy calculator (EC) and is associated with the following devices and/or functions: - a volume conversion device (VCD) or a flow computer used as gas meter conversion, either conforming to EN 12405-1, or to prEN 12405-3, for high accuracy measurements; - a calorific value determination device (CVDD). Requirements for type approval tests of the devices, not included in the above-mentioned standards are described in appropriate annexes specified in Table 6. For the purpose of this European Standard, the term "volume conversion devices" (VCDs) includes flow computers (FCs). A single calculator may undertake the volume conversion functions for different metering lines.

prEN 14236 Public enquiry
Comment end date 2026-04-07
Ultrasonic domestic gas meters

This document specifies requirements and tests for the construction, performance and safety of class 1,0 and class 1,5 battery powered ultrasonic gas meters (hereinafter referred to as meters), having co-axial single pipe, or two pipe connections, used to measure volumes of distributed fuel gases of the 2nd and/or 3rd family gases as given in EN 437:2021, at maximum working pressures not exceeding 0,5 bar )) and maximum actual flow rates of up to 40 m3/h over a minimum ambient temperature range of −10 °C to +40 °C, and minimum gas temperature span of 40 K. This document applies to meters where the measuring element and the register(s) are enclosed in the same case. This document applies to meters with and without built-in temperature conversion, that are installed in locations with vibration and shocks of low significance and in - closed locations (indoor or outdoor with protection as specified by the manufacturer) with condensing or with non-condensing humidity; or, if specified by the manufacturer; - open locations (outdoor without any covering) both with condensing humidity or with non-condensing humidity; and in locations with electromagnetic disturbances likely to be found in residential, commercial and light industrial use. Unless otherwise stated, all pressures given in this document are gauge pressures. Clauses 1 to 14 are for design and type testing only. Requirements for electronic indexes, batteries, valves incorporated in the meter and other additional functionalities are given in EN 16314:2013 Unless otherwise stated in a particular test, the tests are carried out on meters that include additional functionality devices intended by the manufacturer. When more than one meter type is submitted for testing, then each meter type needs to be tested against this document.

Quick filters

Technical Committee
TK 1 Electronics (8) TK 5 Electrical engineering (26) TK 6 Fruit and vegetables products (1) TK 8 Electromagnetic compatibility (1) TK 9 Furniture (2) TK 12 Motor - roads (5) TK 13 Agricultural engineering (3) TK 18 Telecommunications (8) TK 19 Concrete and reinforced concrete (1) TK 20 Toys, child use articles, sports and other recreational equipment (1) TK 21 Textiles and personal protective equipment (2) TK 23 Ceramic tiles, masonry and natural stones (2) TK 28 Gas systems (2) TK 32 Health (22) TK 33 Fishery (2) TK 34 Metrology (2) TK 35 Safety of machinery (3) TK 36 Environmental protection (5) TK 39 Protection (1) TK 40 Petroleuml, petroleum products, lubricants and alternative fuels (3) TK 41 Welding (3) TK 43 Railway traffic (1) TK 45 Electric power (20) TK 49 Metallic materials (5) TK 50 Heating and Ventilation Systems (3) TK 51 Food analysis- Horizontal methods (4) TK 54 Assistive products for persons with disability (1) TK 57 Fertilizers (36) TK 59 Geotechnics (2) TK 60 Windows and doors (1) TK 63 Gas cylinders and cryogenic vessels (2) TK 64 Ergonomics (1) TK 65 Tourism services (2) TK 66 Non-destructive testing (1) TK 68 Plastics (4) TK 70 Pulp, paper, board, adhesives (8) TK 76 Explosive atmospheres (1) TK 77 Lifts (1) TK 79 IT security techniques (5) TK 82 Safety of trackless overground vehicles (1) TK 84 Chimneys and solid fuel burning appliances (1) TK 87 Biotechnology (1) TK 88 Building Information Modelling (BIM) (3) TK 91 Asset management and technical maintenance (1) TK 92 Public Procurement (3) TK 99 Health Informatics (3)
ICS
Dirvožemio kokybė ir dirvotyra. Bendrieji dalykai (1) Vandenilio technologijos (1) Žemės ūkis (Žodynai) (2) Adhesives (1) Aerospace electric equipment and systems (1) Agricultural machines and equipment in general (1) Alarm and warning systems (1) Alkaline secondary cells and batteries (6) Aluminium products (2) Anaesthetic, respiratory and reanimation equipment (1) Application of information technology in general (1) Automatic controls for household use (1) Binders. Sealing materials (2) Biobased products (1) Biology. Botany. Zoology (1) Body care equipment (1) Bolts, screws, studs (1) Brazing and soldering (1) Cables (1) Cement. Gypsum. Lime. Mortar (1) Cereals, pulses and derived products (1) Chemical analysis of metals (1) Chemical laboratories. Laboratory equipment (3) Cleaning appliances (1) Components and accessories in general (1) Components for rotating machines (1) Construction of railways (1) Copper products (1) Corrosion of metals (1) Dental instruments (1) Dental materials (6) Domestic safety (2) Earthworks. Excavations. Foundation construction. Underground works (2) Electric road vehicles (1) Electrical and electronic equipment (1) Electrical and electronic testing (1) Electrical apparatus for explosive atmospheres (1) Electrical engineering in general (1) Electricity supply systems (1) Electroacoustics (1) Electronics (Vocabularies) (1) Explosives. Pyrotechnics and fireworks (1) Ferrous alloys in general (1) Fertilizers (33) Fibre optic interconnecting devices (2) Fibres and cables (6) Finances. Banking. Monetary systems. Insurance (1) Fish and fishery products (1) Floor coverings (2) Fruits and derived products (2) Fuses and other overcurrent protection devices (7) Gas supply systems (2) Gases for industrial application (1) Geology. Meteorology. Hydrology (1) Geometrical Product Specification (GPS) (1) Glass in building (1) Health care technology (Vocabularies) (1) Heat pumps (1) Ignitability and burning behaviour of materials and products (1) Immunity (1) Implants for surgery, prosthetics and orthotics (1) Industrial process measurement and control (1) Information technology (IT) in general (3) Inland navigation vessels (1) Iron and steel forgings (1) IT applications in building and construction industry (3) IT applications in health care technology (3) IT applications in trade (2) IT Security (7) Laminated sheets (1) Leather and furs (2) Leisure and tourism in general (1) Lifts. Escalators (1) Low voltage switchgear and controlgear (2) Luminaires (1) Maintenance services. Facilities management (1) Materials and articles in contact with foodstuffs (1) Materials for aerospace construction in general (1) Measurement of electrical and magnetic quantities (1) Mechanical structures for electronic equipment (2) Medical equipment in general (1) Medical microbiology (1) Mineral materials and products (2) Noise emitted by machines and equipment (1) Non-destructive testing (1) Nuclear power plants. Safety (1) Nuts (2) Organic coatings (1) Other construction materials (4) Other equipment related to power transmission and distribution networks (1) Other wood-based panels (1) Outdoor and water sports equipment (1) Paints and varnishes (2) Paper and board (2) Passenger and cabin equipmen (1) Petroleum products and natural gas handling equipment (1) Petroleum products in general (3) Pipeline components and pipelines in general (1) Plastics pipes (1) Plastics pipes and fittings for non fluid use (1) Pollution, pollution control and conservation (3) Power transmission and distribution lines (1) Power transmission and distribution networks in general (1) Product life-cycles (1) Properties of surfaces (1) Pumps and motors (1) Purchasing. Procurement. Logistics (1) Radiation protection (1) Rectifiers. Converters. Stabilized power supply (1) Recycling (1) Respiratory protective devices (1) Road construction (1) Rotating machinery in general (2) Safety of machinery (5) Screw threads (1) Semiconductor devices in general (3) Services for companies (1) Services for consumers (1) Small kitchen appliances (1) Software (1) Solar energy engineering (1) Solid fuel heaters (1) Steels (1) Sterilized packaging (4) Sterilizing equipment (1) Switches (2) Syringes, needles and catheters (3) Technical product documentation (1) Telecommunications in general (1) TELECOMMUNICATIONS. AUDIO AND VIDEO ENGINEERING (8) Telecontrol. Telemetering (7) Test conditions and procedures in general (1) Textile fibres in general (1) Textiles in general (1) Thermistors (1) Transfusion, infusion and injection equipment (3) Vegetables and derived products (1) Ventilation and air-conditioning systems (1) Ventilators. Fans. Air-conditioners (1) Water heating equipment (1) Waxes, bituminous materials and other petroleum products (2) Welding equipment (2) Welding, brazing and soldering in general (1) Woodworking machines (1) Workplace atmospheres (1)