Standartų projektų sąrašas

Paieškos frazė

Išplėstinė paieška

Žymuo

Direktyvos

Organizacija

ICS

Technikos komitetas

Užsienio komitetas

Darbo grupė

Etapas

Būsena

Komentavimo data

iki

Rezultatai

prEN ISO 12625-8 Viešoji apklausa

Komentavimo iki data 2026-08-06

Minkštasis popierius ir jo gaminiai. 8 dalis. Vandens sugerties trukmės ir vandens įmirkio nustatymas krepšelio panardinimo metodu (ISO/DIS 12625-8:2026)

ISO 12625-8:2010 specifies a basket-immersion test method for the determination of water-absorption time and water-absorption capacity of tissue paper and tissue products. It is expressly stated that the detection of impurities and contraries in tissue paper and tissue products be applied according to ISO 15755. For the determination of moisture content in tissue paper and tissue products, ISO 287 is applicable.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

prEN ISO 1924-2 Viešoji apklausa

Komentavimo iki data 2026-07-30

Popierius ir kartonas. Savybių nustatymas tempiant. 2 dalis. Pailgėjimo tempiant pastoviu greičiu metodas (20 mm/min) (ISO/DIS 1924-2:2026)

ISO 1924-2:2008 specifies a method for measuring the tensile strength, strain at break and tensile energy absorption of paper and board, using a testing machine operating at a constant rate of elongation (20 mm/min). ISO 1924-2:2008 also specifies equations for calculating the tensile index, the tensile energy absorption index and the modulus of elasticity. Testing in conformance with ISO 1924-2:2008 always includes the measurement of tensile strength. Measurement or calculation of other properties is subject to agreement between the parties concerned. ISO 1924-2:2008 is applicable to all papers and boards, including papers with a high strain at break if the results are within the capacity of the testing machine. It also applies to the components of corrugated board but not, however, to corrugated board itself.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

prEN 646 Viešoji apklausa

Komentavimo iki data 2026-07-21

Su maisto produktais susiliečiantis popierius ir kartonas. Dažyto popieriaus ir kartono spalvos atsparumo nustatymas

This document describes procedures for the testing of dyed paper and board intended to come into contact with foodstuffs. Some procedures depending on the foreseeable use of the material are given. Visual evaluation against a grey scale provides grading of the bleeding. For samples having significant different sides, a migration can occur from one glass fibre to the other and could lead to wrong interpretation of the fastness of one side. It is advisable to check these samples using large sampling procedure to prevent cross contamination of the glass fibre during the migration procedure. The procedure is described in Annex A. If lower limit of detection is required, this procedure could also be used.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

prEN ISO 186 Viešoji apklausa

Komentavimo iki data 2026-07-21

Popierius ir kartonas. Atranka vidutinei kokybei nustatyti (ISO/DIS 186:2026)

This Iinternational Standard specifies a method of obtaining a representative sample from a lot of paper or board, including solid and corrugated fibreboard (see ISO 4046:1978), for testing to determine whether or not its average quality complies with set specifications. It defines the conditions which apply when sampling is carried out to resolve disputes between buyer and seller relating to a defined lot of paper or board, which has been or is being delivered. NOTE If less than 50 % of the lot is available for sampling, then sampling in terms of this International Standard will be invalid in the absence of agreement to the contrary. The method is unsuitable for determining the variability within a lot. In cases where International Standards make reference to sampling according to this standard but where such sampling is impossible, impractical or inappropriate, and where no dispute is involved, guidance is given in normative annex A.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

prEN ISO 287 Naujas

Komentavimo iki data 2026-06-18

Popierius ir kartonas. Partijos drėgmės kiekio nustatymas. Džiovinimo krosnyje metodas (ISO 287:2026)

ISO 287:2017 specifies an oven-drying method for the determination of the moisture content of a lot of paper and board. The procedure in Clause 8, describing how the test pieces are drawn from the lot, is performed at the time of sampling. ISO 287:2017 is applicable to every type of lot of paper and board, including corrugated board and solid board, provided that the paper or board does not contain any substances, other than water, that are volatile at the temperature specified in this document. NOTE For determination of the dry matter content of a sample of paper or board, e.g. for calculation of the dry mass of the sample, ISO 638[1] can be used.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

Būtini slapukai

Statistikos slapukai

El. pašto prenumerata

Išplėstinė paieška

Rezultatai

Greitieji filtrai

Organizacija

Technikos komitetas

ICS