Standartų projektų sąrašas

Paieškos frazė

Išplėstinė paieška

Žymuo

Direktyvos

Organizacija

ICS

Technikos komitetas

Užsienio komitetas

Darbo grupė

Etapas

Būsena

Komentavimo data

iki

Rezultatai

prEN 16842-11 Naujas

Komentavimo iki data 2025-06-10

Varikliniai pramoniniai krautuvai. Matomumas. Bandymo metodai ir patikra. 11 dalis. Padėklų krautuvai (valdomi vairuotojo)

This document specifies the requirements and test procedures for 360° visibility of self-propelled industrial rider-controlled pallet-stacking trucks in accordance with ISO 5053-1 (herein after referred to as trucks), without a load and it is intended to be used in conjunction with EN 16842-1. This document also applies to pedestrian controlled trucks with foldable platform when used in ride-on mode. Pedestrian-controlled and pedestrian-propelled trucks are not covered by this document. Where specific requirements in this part are modified from the general requirements in EN 16842-1, the requirements of this part are truck specific and intended to be used for self-propelled industrial stand-on pallet-stacking trucks. This part of EN 16842 deals with all significant hazards, hazardous situations or hazardous events relevant to the visibility of the operator for applicable machines when used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

prEN ISO 10896-2 Viešoji apklausa

Komentavimo iki data 2025-05-19

Visureigiai krautuvai. Saugos reikalavimai ir patikrinimas. 2 dalis. Sukiojamieji krautuvai (ISO/DIS 10896-2:2024)

ISO 10896-2:2016 specifies general safety requirements for slewing rough-terrain variable-reach trucks (hereafter known as "trucks"), consisting of a lower chassis with a slewing upper structure equipped with a telescopic lifting means (pivoted boom), on which a load handling device (e.g., carriage and fork arms) is typically fitted. Fork arms and other integrated attachments are considered to be parts of the truck. Other standards, in addition to the relevant provisions of this part of ISO 10896, can apply to the attachments. ISO 10896-2:2016 is not applicable to the following: a) rough terrain variable-reach trucks covered by ISO 10896‑1 (non-slewing); b) industrial variable-reach trucks covered by ISO 3691‑2; c) mobile cranes; d) machines designed primarily for earth-moving, such as loaders, even if their buckets are replaced by fork arms (see ISO 20474); e) trucks designed primarily with variable-length load suspension elements (e.g. chain, ropes) from which the load may swing freely in all directions; NOTE Additional requirements for trucks intended for freely swinging load applications, their lifting devices and attachments, and personnel/work platform applications on trucks, are being developed by ISO/TC 110/SC4. f) trucks designed primarily for container handling. The significant hazards covered by this part of ISO 10896 are listed in Annex A. This part of ISO 10896 does not address hazards that can occur - during manufacture, - when handling suspended loads, which may swing freely, - when lifting personnel, - when using trucks on public roads, - when operating in potentially explosive atmospheres, or - with a battery, LPG or hybrid as the primary power source.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

Būtini slapukai

Statistikos slapukai

El. pašto prenumerata

Išplėstinė paieška

Rezultatai

Greitieji filtrai

Organizacija

Technikos komitetas

ICS