Standartų projektų sąrašas

Rezultatai

prEN 1401-1 Viešoji apklausa

Komentavimo iki data 2026-07-03

Beslėgio požeminio nuotakyno plastikinių vamzdžių sistemos. Neplastifikuotas polivinilchloridas (PVC-U). 1 dalis. Vamzdžių, jungiamųjų detalių ir iš jų sudarytos sistemos techniniai reikalavimai

This document specifies the definitions and requirements for solid wall pipes with smooth internal and external surfaces, extruded from the same formulation throughout the wall, fittings and the system of unplasticized poly(vinyl chloride) (PVC-U) piping systems in the field of non-pressure underground drains and sewers for wastewater. NOTE 1 Products complying with this document can also be used in non-pressure underground drains and sewers for surface water. This document also specifies test methods and test parameters. This document is applicable to: — solid wall pipes and fittings which are intended to be used buried underground outside the building structure reflected in the marking of the products by “U”, and — solid wall pipes and fittings which are intended to be used buried underground both outside (application area code “U”) and within the building structure reflecting on the marking of products by “UD”. NOTE 2 Multilayer pipes with different formulations throughout the wall and foamed core pipes are covered by EN 13476-2 [1]. This document covers a range of pipe and fitting sizes, stiffness classes, and gives recommendations concerning colours. NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. In conjunction with CEN/TS 1401-2 [7] it is applicable to PVC-U pipes and fittings, their joints and to joints with components of other plastics and non-plastics materials intended for buried piping systems for non-pressure underground drains and sewers. NOTE 4 Pipes, fittings and other components conforming to any of the plastics product standards listed in Annex C can be used with pipes and fittings conforming to this document, provided they conform to the requirements for joint dimensions given in Clause 10 and to the requirements of Table 16.

Skaityti, komentuoti projektą Peržiūrėti metaduomenis

Išplėstinė paieška

Rezultatai

Greitieji filtrai

Organizacija

Technikos komitetas

ICS

Būtini slapukai

Statistikos slapukai

El. pašto prenumerata

Standartų projektų sąrašas

Išplėstinė paieška

Rezultatai

Greitieji filtrai

Organizacija

Technikos komitetas

ICS